comer

January 20, 2021

Electrical power UNITS FOR LIFT TABLE one
General Description
This energy unit is created exclusively for the smaller lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is extensively utilised while in the marketplace of logistic gadgets for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed from the solenoid valve together with the pace managed from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
General Description
This power unit is intended solely for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve plus the velocity controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the electrical power supply is minimize, the reducing motion is managed through the guide override perform.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is developed exclusively for the huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve as well as the velocity managed by a pressure compensated flow control valve.
Power UNITS FOR LIFT TABLE 4
Basic Description
This energy unit is designed solely for that significant lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as the velocity managed through the adjustable needle valve. Once the lift rises to a high positoin, but the electrical power supply is minimize, the reducing movement is controlled through the manual override function.
Distinctive Notes
1. This energy unit is of S3 duty cycle, which can only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all the hydraulic elements concerned ahead of set up of the energy unit.
three. Viscosity with the oil shoud be 15~46 cst,which really should also be clean and totally free of impurities.N46 hydraulic oil is recommended.
four. Oil transforming is required following the first 100 operation hrs,afterwards after each and every 3000 hrs.
five. The power unit proven is created to be mounted vertically.