FMM Variety Mill Couplings
The FMM Type coupling consists of 1 standard flex hub, one universal straight bored hub as standard, two sleeves and a single accessory kit. This coupling is supplied with exposed bolts as typical. Shrouded bolts can be found upon request through size 5.5.
Functions
For extended life
Regular 20° strain angle
Heat taken care of bolts for higher power
Corrosion resistant bolts and nuts for ease of servicing
Gives parallel, angular misalignment and finish float
Flex Half coupling interchangeable with market specifications
Lengthy Universal Hub supplied to consumer specifications with straight or tapered bores
Ordering Information
Application: Driver and Driven.
Sort and size of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance involving shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is needed.
Specify counterbore dimensions if preferred.
Submit a drawing if accessible.
FHDFS Form Floating Shaft Couplings
The FHDFS Form coupling includes two flex-rigid couplings and 1 floating shaft. The coupling is supplied with all the rigid hubs outboard except if otherwise specified. The coupling includes exposed bolts only.
Characteristics
Flex Hubs for long life
Conventional 20° stress angle
Heat handled bolts for higher strength
Corrosion resistant bolts and nuts for ease of upkeep
Accommodates parallel and angular misalignment
Removal of center assembly allows forease of maintenance without the need of repositioning machinery
Rigid hubs outboard permits for larger shaft diameters
Created for high-torque low-speed applications that take place in mill operations
Ordering Data
Application: Driver and Driven.
Sort and dimension of coupling, horizontal, vertical and so on.
Power: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Connecting products shaft sizes.
Specify which hubs are for being employed to the products (Rigid or Flex).
Rigid hubs is going to be utilised around the equipment unless of course otherwise specified.
Length 
of floating shaft may impact max angular misalignment.