Material Handling Power UNIT 2
Common Description
This power unit options power up gravity down circuit. Activate the start off solenoid to start the motor to lift the machine. The lowing motion is activated by the solenoid valve with the lowering speed managed by the strain compensated flow manage valve. Products of this series might be extensively used in the market of logistic units like fork lift, mini lift table, etc.
Special Notes
one. The duty of this power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic elements concerned prior to mounting the 
electrical power unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities, N46 hydraulic oil is recommended .
four. Oil modifying is needed following the original a hundred operation hrs,afterwards once every 3000 hours.
five. The electrical power unit should be mounted horizontally.
Material Handling Electrical power UNIT one
Common Description
This electrical power unit is designed for that fork lift marketplace, consisting of very effective gear pump, DC motor, guide increase and reduced valve, tank, ect. The up and down movement are controlled from the lever of your manual release valve, which is equipped with an electrical switch to activate the motor. The lowing pace is controlled through the pressure compensated flow management valve.
Particular Notes
1. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean every one of the hydraulic parts concerned prior to set up of the energy unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst, which should also be clean and free of impurities, N46 hydraulic oil is advisable .
4. Oil modifying is required right after the original one hundred operation hrs, afterwards when just about every 3000 hrs.
5. The energy unit shown is built to be mounted horizontally.